How To Connect Computer Using a STRAIGHT Cable on a LAN Network

Before we begin to connect the computer to the LAN network, we must first prepare his tools :

1. ROUTER
    The ROUTER is the heart of the network. The router serves to connect 
    one network to another network In this case , the router connects to 
    the Internet network LAN network
2. SWITCH
    In contrast to routers , switches serves to connect each computer on 
    a LAN network
3. ETHERNET CARD
    Ethernet card is an adapter to plug the ethernet cable so that
    the computer can connect to the network . Usually , the latest
    computers , these cards have been pinned on board so you do not
    need  to buy again .
4. ETHERNET CABLE
    That is the cable used to connect a computer to the router or it could
    be a computer with another computer . End of the cable is given
    a connector called an RJ - 45 . RJ - 45 has 2 settings , ie STRAIGHT
    and CROSS . STRAIGHT is used to connect a computer to the router while
    the CROSS is used to connect a computer directly to a computer .
5. MODEM
    If you want to connect your network to the Internet , then you also
    have to buy a modem . If you do not buy a modem , then your 
    computer can only communicate with other computers that are on the
    LAN network .
6. OTHER EQUIPMENT
    Crimping tool , LAN tester , scissors , multimeter .
    Crimping tool is used to connect the RJ - 45 ethernet cable . LAN
    cable tester is used for testing LAN is not functioning atai . 
    As an alternative to speed up or simplify your job , you can ask for  
    help to the seller , for example the ethernet cable to the RJ - 45 pair
    at a time so you just pair cables to the router and the computer .

    This is a sample image to construct a LAN network

Connecting to enable Internet Sharing

1. Right Click if your computer is not connected

 2. klik Open NETWORK AND SHARING CENTER

    

    

3. CLIK ETHERNET

4. CLIK PROPERTIES

5. SELECT INTERNET PROTOCOL VERSION 4 (TCP/IPv4), then clik OK or PROPERTIES

 

6. Clik use the following IP ADRESSs, here we will fill IP ADRESS
    Then the one below it click use the following DNS Server Addresses

   

After entering the IP ADDRES, then click OK

7. Your computer is connected to the internet